Mod Archive Forums
Music Production => MilkyTracker Bug Reports => MilkyTracker => Tracking => Bug Report Archive => Topic started by: raina on July 17, 2007, 12:49:01
-
The following bugs have been confirmed for release v0.90.60:
- Fixed. CRASH/FREEZE: When trying apply crossfade on invalid selections in sample editor.
- The selection should encompass one, and only one loop point, see here (http://www.milkytracker.net/milkyboards/viewtopic.php?p=3865#3865). Best learn it now, in the future crossfade will be disabled until a valid selection is made.
- Fixed. FREEZE: Optimize song can freeze MilkyTracker if the displayed pattern number no longer exists after optimization.
- Workaround: Ensure pattern #0 is displayed before optimizing, and always save any unsaved work.
- 0xy arpeggio replay difference comparing to Ft2 when song speed is 16 or higher.
- Fixed. Bug in the XI-loader causes instrument vibrato settings not to be applied until some instrument setting is modified.
- Certain hot words in song titles may still cause incorrect module format detection.
- Fixed. Cutting arpeggio commands by selecting only the operand digits leaves invisible 000 commands on the pattern that repeat the previous arpeggio from effect memory.
- Saving the module either makes the 000's disappear or turns them into the corresponding full arpeggio command depending on whether arpeggio was used before them.
- Fixed. Dxx on the last order ignores the Replay start order number.
- E3x glissando control is not implemented.
- E4x vibrato control is not implemented.
- E5x set finetune is played Ft2-like in in all playback modes.
- E7x tremolo control is not implemented.
- It should be possible to use the instrument fadeout without having the volume envelope enabled by using a set volume command (xx/Cxx) simultaneously or after a key-off.
- Milky doesn't always start in Ft2 playback mode because the last used mode is remembered between sessions.
- The optimal behavior is being discussed.
- Fixed. Milky's note range goes slightly higher than that of Ft2's.
- Fixed. Multisample GUS .pat instruments are imported with relative note values that are way off.
- New. Fixed. Note pitch isn't reset after a portamento when 4xx follows a Vx.
- Portamento overflow "effect" isn't reproduced
- Simultaneous E6x pattern loop and EEy pattern delay replay differs from Ft2.
- Fixed. Some custom screen resolutions lead to distorted rendering.
- Fixed. The Apple AIFF loader doesn't load big endian samples correctly.
- Workaround: Load the sample and change its byte order in the sample editor.
- ?x Volume column effects used in conjunction with EDx note delay cause slight replay differences comparing to Ft2.