Print

[ThomasMLS]

Hi.

I recently upgraded from Windows 10 to Windows 11 on my primary computer, and I found that whenever I click on "Load", then an integrated file loader shows up in-editor rather than the Windows File Dialog I expected.

Is there I way I can force the File Dialog to show up in place of the in-editor loader in Windows 11?
Could I have missed a setting despite looking in the 5 categories in the "Config" menu?
Otherwise, I have been unsuccessful tampering with the Run in compability mode settings, and I hope I do not have to set up a VM running Windows 10 or older to fix this.

This question applies to at least MilkyTracker version 1.03 - 1.05 (I have not yet tested 1.02 and below), and on my secondary computer which still runs Windows 10, version 1.05 still gives me the File Dialog.

Thank you in advance.